The Jasco Z-Wave Plus Smart Dimmer With QuickFit And SimpleWire adds Z-Wave remote and local On/Off/Dim/Brighten control for a wired light or appliance. The dimmer switch can be installed in single or multi-way wire applications and included in multiple automation scenes. A blue LED indicator leads you to the switch in the dark. Works with most dimmable LED, CFL, halogen and all incandescent bulbs. Supports Advanced Configuration; Dim rates, LED status, minimum and maximum dim levels, alternate exclusion Features QuickFit™ – Improved components reduce the housing depth by up to 20 percent compared to previous models and eliminated the need for heat tabs. SimpleWire™ – Dual ground ports, which are offset to avoid switch box mounting screws, support daisy-chaining in multi-switch setups May be used in single pole installation or with up to four Jasco model 45710 or 46560 Add-on switches in 3, 4, 5 or 6-way wiring configurations Screw Terminal installation; requires wiring connections for Line (Hot), Load, Neutral and Ground. Traveler wire required for multi pole installation Power: 120VAC, 60Hz Signal Frequency: 908.4/916MHz Maximum Load: 600W Incandescent, 300 Dimmable CFL/LED Range: Up to 150 feet from controller or closest Z-Wave device Operating Temperature: 32-104° F (0-40° C) Bell Smart Home customers who currently have an automation device such as a smart door lock, smart thermostat or smart light bulb can add this device. Bell Smart Home customers who currently have an automation device such as a smart door lock, smart thermostat or smart light bulb can add this device. If you have any questions regarding eligibility please contact Bell Smart Home in your region: Ontario and Québec: 1 877 267-2004, Manitoba: 1 866 949-0078, New Brunswick, Nova Scotia, Newfoundland and Labrador and PEI: 1 844 474-2023.